This textbook pioneered the approach whereby both properties and processing of reinforced and unreinforced plastics are covered in a single volume. It assumes no prior knowledge of plastics, and emphasizes the practical aspects of the subject. In this third edition, over half the book has been re-written and the remainder has been updated and re-organized. Early chapters give an introduction to the types of plastics that are currently available and describe how a designer goes about the selection of a plastic for a particular application. Later chapters lead the reader into more advanced aspects of mechanical design and analysis of polymer melt flow. All techniques developed are illustrated by numerous worked examples, and problems are given at the end of each chapter - the solutions to which form one of the appendices.